Pages: [1]   Go Down
Print
Author Topic: Koreksi governor terbalik ?  (Read 4635 times) Bookmark and Share
0 Members and 1 Guest are viewing this topic.
mBanks
Jr. Member
**
Offline Offline

Gender: Male
No.INA: 0200
Posts: 63



View Profile
« on: March 09, 2009, 03:54:12 PM »

Kenapa ya, kalo saya aktifkan governor malah rpm melorot terus, dari hover dengan posisi collective stick ditengah, makin lama heli makin melorot bersamaan dengan itu suara mesinnyapun makin melorot, kalo dibiarkan seperti itu, helinya landing sendiri dengan collective stick pada posisi full. Susahnya, hal tsb tidak selalu terjadi .. saya ada 2 heli similiar yg mengalami hal ini, berlangsung sejak barang2 ini baru dipasang.
Kalo governornya off, semua baik2 saja, rpm konstan pada rpm kurang lebih 1550. Saya familiar dengan governor jenis ini sejak thn 1997.

Spec:
Governornya Futaba GV1 (relative baru,kira2 1thn)
Radio 12Z (same result dengan 9Z, rpm mlorot)
Servo throttle Fut. 9255 (same result dengan JR2700,Hitec325, mlorot juga)

Sensor di 97%, limit sudah diset, setting gear ratio cocok.

Karena terkesan seperti governor ngoreksinya terbalik, meskipun ga relevan, saya coba me reverse MSx di governornya, sami mawon sama saja, rpm mlorot.

Any idea ?
Logged

thx,
Bambang Agus S
Chakra
Moderator
Jr. Member
*****
Offline Offline

Posts: 84


View Profile
« Reply #1 on: March 11, 2009, 01:07:09 PM »

Saya baca di RR:
Gunner,
Yes we had an issue with one of the Guys heli. All of theirs are set the same but then some where along the line nothing worked and it puzzled me. We then switch the wires around from Channel 7 to 8 and everthing work again.

It took awhile to figure out and yes it could be in the receiver. I do known that with the 14mz and 12mz channel 7 cannot be use for the Gov. Its also
annotated in Futaba\'s site

Pernah dicoba Mbang?
Dulu kita pakai GV-1 kok nggak pernah ada masalah seperti ini?
Logged
mBanks
Jr. Member
**
Offline Offline

Gender: Male
No.INA: 0200
Posts: 63



View Profile
« Reply #2 on: March 16, 2009, 07:29:24 PM »

Kemarin hari Rabu saya coba seperti itu, tapi masih tetap saja rpm melorot. Saya coba gali lebih jauh lagi di RR rujukan pak Chakra, dan saya menemukan bahwa atv throttle tidak boleh lebih kecil dari 85%, sedangkan di tx saya atv throttle adalah 80%, berdasakan hal itu, maka saya ubah menjadi 100% di kedua sisi dan throttle linkage disesuaikan. Hari sabtu dan minggu saya coba lagi, dan untuk sementara waktu saya bisa katakan bahwa rpm tidak melorot seperti biasanya.
Logged

thx,
Bambang Agus S
Chakra
Moderator
Jr. Member
*****
Offline Offline

Posts: 84


View Profile
« Reply #3 on: March 16, 2009, 08:03:38 PM »

Haha, kalau sudah ketemu masalahnya rasanya lega ya?
Biasanya anda cukup teliti, di manualnya kan bilang ATV sedekat mungkin 100%.
Selamat berlatih untuk kejurda . .
Logged
Pages: [1]   Go Up
Print
Jump to: